级间进出口几何角度对压气机气动性能和封严效果的影响

为了削弱级间泄漏流对压气机性能的不利影响,提出了一种基于Coanda型几何进出口的级间结构,并以一个亚声速单级轴流压气机为研究对象,数值模拟了5°,10°,20°三种不同级间进出口几何角度对压气机性能的影响。结果表明:改进后的级间进出口几何结构使得压气机流量和效率均略有提升。分析原因是级间出口泄漏流以较小角度与主流汇合,增大了静叶进口气流的轴向速度、径向速度,使得静子通道流动堵塞程度减轻,总压损失减小,扩压能力增强。同时,新结构还减小了级间泄漏流的流量系数,改善了级间封严效果。5°,10°,20°角度下的压气机效率最大分别提升了0.68%,0.63%,0.62%。     

翅片位置对复合式减涡器减阻性能影响数值模拟

为了探索翅片-管复合式减涡器的翅片安装位置对共转盘腔径向内流压力损失的影响规律,对不同转速、翅片周向位置及安装角度下的去旋系统开展了数值研究,得到了不同工况下共转盘腔径向内流的流场结构及压力损失分布曲线。研究结果表明:减涡管能引导流体径向流入,并降低流体的旋流比;相比于管式减涡器,翅片-管复合式减涡器能明显降低盘腔内的总压损失;在不同旋转雷诺数下,翅片的周向安装位置α及安装角β均存在最佳值;在中、高旋转雷诺数下,最佳值分别为α=9°,β=30°,最佳结构下总压损失较基础模型低40%左右;改变翅片周向位置及安装角度可以明显改变气流进入减涡管的角度,在较优情况下,可以减小流体流入减涡管的阻力及在减涡管内的流动阻力,整体上减小了盘腔内总压损失。     

周向总压畸变对对转压气机影响效应分析

以对转压气机为研究对象,在数值方法校验的基础上,应用全通道定常流场分析手段计算了对转压气机不同周向畸变条件下的三维流场,获取了周向总压进气畸变对该压气机性能以及流场结构的影响效应,确定了对转压气机的临界畸变角,分析了不同畸变强度对压气机性能的影响规律,探讨了周向总压畸变在对转压气机中的发展演化过程。结果表明:(a)所研究的对转压气机临界畸变角约为72°,略高于传统动-静叶排交替的压气机临界畸变角;(b)相比均匀进气工况,当畸变指数为0.24时,对转压气机失速点压比和失速裕度分别下降3%和9.6%,当畸变指数为0.5时二者分别下降8.3%和19.8%;(c)未畸变区与畸变区流体之间存在的压力梯度影响转子叶片相对来流速度。进入畸变区叶片来流相对速度减小,负荷降低,退出畸变区叶片来流相对速度增大,负荷增大;(d)上游转子使得畸变水平提高,下游转子反向旋转效应抑制了来流相对速度变化趋势,增强了气流在其叶片通道中的掺混,使得畸变水平有所下降。     

超声速串列静叶积叠优化分析

在进口超声速、气流转折角大的高负荷条件下,静叶通道中激波强度高,激波、附面层干扰引起的损失大,且静叶中三维流动引起的径向载荷分布不均匀,易产生角区分离。叶片积叠优化是提高风扇性能的一项有效技术。采用数值模拟的方式研究了不同积叠形式对优化串列静叶沿展向激波结构,改善叶排间流动匹配的作用。三维流动对比分析可以得出:高负荷串列静叶采用正弓形积叠,叶片展向载荷分布合理,静叶端壁角区分离损失减小,前后叶片排流动匹配较好,风扇性能进一步提高。     

高分影像辅助下的航空高光谱严密几何检校方法

 惯性测量单元(IMU)与传感器视准轴的偏心角和偏心矢量是造成航空线阵列高光谱数据几何校正误差的主要原因之一。在分析偏心角与偏心矢量误差来源之后提出该误差由IMU主轴与传感器主轴的角度偏差、测区固定偏差、GPS中心与传感器投影中心相对偏差组成,在此基础上建立了较为严密的检校模型。针对模型解算时需要大量高精度控制点的问题,提出了一种高分影像辅助下的亚像元精度控制点自动提取方法。通过多地区、多传感器高光谱航测实验表明,亚像元精度控制点能有效提高模型解算精度。新检校模型可获得亚像元校正精度,推扫式传感器——应用型机载成像光谱仪(AISA)建模中误差约为0.39个像元,摆扫式传感器——实用型模块化成像光谱仪(OMIS)建模中误差约为0.23个像元,校正后的影像可直接进行拼接。     

How do interplanetary shock impact angles control the size of the geoeffective magnetosphere?

In this paper, we investigate temporal and spatial magnetosphere response to the impact of interplanetary (IP) shocks with different inclinations and speeds on the Earth’s magnetosphere. A data set with more than 500 IP shocks is used to identify positive sudden impulse (SI⁺) events as expressed by the SuperMAG partial ring current index. The SI⁺ rise time (RT), defined as the time interval between compression onset and maximum SI⁺ signature, is obtained for each event. We use RT and a model suggested by Takeuchi et al. (2002) to calculate the geoeffective magnetospheric distance (GMD) in the shock propagation direction as a function of shock impact angle and speed for each event. GMD is a generalization of the geoeffective magnetosphere length (GML) suggested by Takeuchi et al. (2002), defined from the subsolar point along the X line toward the tail. We estimate statistical GMD and GML values which are then reported for the first time. We also show that, similarly to well-known results for RT, the highest correlation coefficient for the GMD and impact angle is found for shocks with high speeds and small impact angles, and the faster and more frontal the shock, the smaller the GMD. This result indicates that the magnetospheric response depends heavily on shock impact angle. With these results, we argue that the prediction and forecasting of space weather events, such as those caused by coronal mass ejections, will not be accurately accomplished if the disturbances’ angles of impact are not considered as an important parameter within model and observation scheme capabilities.     

过虚拟交班点的能量最优制导律

针对固定目标的导弹过虚拟交班点制导问题，在希尔伯特空间下，基于最优化理论设计了有无终端落角约束两种情况下的全局能量最优制导律。通过对模型进行线性化，将提出的最优制导模型转化为线性二次型最优控制问题，在此基础上利用零控脱靶量（ZEM）概念对系统模型进行降阶，并推导出解析解。设计的制导律可以使导弹准确经过虚拟交班点，并实现期望终端落角。仿真结果表明，与经典制导律对比，该制导律可以显著减少全局控制能量消耗。     

双馈风机接入对系统极限切除角的影响

风电场的大规模接入对电网暂态稳定性造成的影响不容忽视。以含双馈风电机组的扩展两机系统为例,建立了双馈风机等值模型,将两机系统等值成单机无穷大系统,依据等面积法则详细推导了风电接入后系统极限切除角的解析式,进而定量分析了极限切除角随风电比例、风机并网位置、故障位置和负荷接入位置等4个影响因素的变化趋势,总结出4种影响因素对暂态功角稳定性的影响规律。在BPA和FASTEST中分别建立含双馈风机的扩展双机系统的仿真模型,对理论分析工作的正确性进行了仿真验证。     

HB-2 high-velocity correlation model at high angles of attack in supersonic wind tunnel tests

Responding to a need for experimental data on a standard wind tunnel model at high angles of attack in the supersonic speed range, and in the absence of suitable reference data, a series of tests of two HB-2 standard models of different sizes was performed in the T-38 trisonic wind tunnel of Vojnotehnickˇi Institut(VTI), in the Mach number range 1.5–4.0, at angles of attack up to+30°. Tests were performed at relatively high Reynolds numbers of 2.2 millions to 4.5 millions(based on model forebody diameter). Results were compared with available low angle of attack data from other facilities, and, as a good agreement was found, it was assumed that, by implication, the obtained high angle of attack results were valid as well. Therefore, the results can be used as a reference database for the HB-2 model at high angles of attack in the supersonic speed range, which was not available before. The results are presented in comparison with available reference data, but also contain data for some Mach numbers not given in other publications.     

反向交叉眼对单脉冲雷达干扰效果分析及仿真验证

交叉眼干扰被认为是对单脉冲雷达干扰最有效的方式之一。基于雷达方程建立了隔离平台回波下的两点源反向交叉眼干扰模型，推导了交叉眼干扰欺骗角一般性公式，研究了干扰机发射天线间距、干扰平台旋转角和干扰机相对雷达之间距离等参数变化对角度欺骗效果的影响，并依据单脉冲雷达接收机获取角度的信息处理流程，建立了单脉冲雷达接收机仿真模型，对交叉眼数学模型的正确性和局限性进行了分析。研究结果表明：单脉冲雷达越靠近两点源交叉眼干扰机中心线、干扰机两发射天线间距越大、与干扰机距离越近时，角度欺骗效果越好；单脉冲雷达的欺骗角度随着与干扰机距离的接近呈指数式增大；数学模型和仿真模型计算的单脉冲雷达角度误差最大值随干扰机天线与雷达天线中心连线的夹角的增大呈指数化增长。研究可为交叉眼干扰工程设计作参考。